化糞池模具的結構外形一般為橫放的圓筒狀,兩端封頭一般采用力學性能良好的車輪狀凹凸面設計,內部設有相通的隔艙板,隔艙板上一般設有立體彈性填料,用來截留更多的厭氧細菌。而新型化糞池模具比常見的多了一道發酵腐化的工序,工藝更細化,水質更干凈?；S池應設計與綠化帶內,若置于道路地段,可通行人及小型車,,混凝土厚度不低于 15cm?；S池模具爆裂原因有很多,今天我們先從加工工藝方面簡單說一下：模具材質不好在后續加工中容易碎裂,熱處理,淬火回火工藝不當產生變形;模具研磨平面度不夠,產生撓曲變形;模具強度不夠,刀口間距太近,模具結構不合理,模板塊數不夠無墊板墊腳;線割處理不當,拉線線割,間隙不對,沒作清角;沖床設備的選用,沖床噸位,沖裁力不夠,調模下得太深;生產前無退磁處理,無退料梢;生產中有斷針斷彈簧等卡料;疊片沖壓,定位不到位,模板有裂紋仍繼續生產。
The structure and shape of the septic tank die are generally in the form of a horizontal cylinder, and the www.gangsisheng.org.cnwww.chongmianji.com.cnwww.chuanxianguan.com.cnwww.yinfengji.com.cnwww.hongganjixie.com.cn www.shusongji.net.cnend seal head is generally designed with a good mechanical wheel concave convex surface, with a interconnected spacer plate inside, and a three-dimensional elastic packing on the board, which is used to intercept more anaerobic bacteria. The new septic tank mold is more common than the usual fermentation and putrefaction process, the process is more detailed and the water quality is cleaner. Septic tanks should be designed with green belts, if placed in road areas, passable persons and small cars, and concrete thickness of not less than 15cm. There are many reasons for the bursting of septic tank molds. Today, we first simply say from the processing technology that the mold material is not easy to crack in the subsequent processing, heat treatment, quenching and tempering process is unsuitable to produce deformation; the mould grinding planeness is not enough to produce flexure deformation; the die strength is not enough, the gap between the blade is too close, the die structure is unreasonable, die The plate number is not enough without the cushion foot pad; the line cutting is improper, the drawing line cutting, the gap is wrong, no clear angle; the selection of the punch equipment, the punching machine tonnage, the blanking force is too deep; no demagnetization treatment, no redeing tip before production; the production has broken pin spring and other cards; the laminated punching, the positioning is not in place, the template has cracks continue to produce.